|
A setting commonly adjusted using a jumper
found on a computer peripheral,
such as a hard disk drive or
CD-ROM drive as shown below. This setting sets the drive to be the
primary drive and allows for multiple devices to be connected to a single connection. Computers
can only have one master per channel on a single IDE/EIDE cable and other drives connected to the same cable would be set as slave or cable select. 
- See document CH000695
for additional information about having more than four IDE devices
connected to a computer.
- Additional information about having multiple master drives can
be found on document CH000862.
Also see: Cable select,
CD-ROM
definitions, DS, Hard disk drive definitions,
Jumper,
Slave
|
|
| Resolved |
Were you able to locate the answer to your questions? |
|
|
